Low thermal conductivity in porous SiC–SiO2–Al2O3–TiO2 ceramics induced by multiphase thermal resistance

The introduction of multiple heterogeneous interfaces in a ceramic is an efficient way to increase its thermal resistance. Novel porous SiC–SiO₂–Al₂O₃–TiO₂ (SSAT) ceramics were fabricated to achieve multiple heterogeneous interfaces by sintering equal volumes of SiC, SiO₂, Al₂O₃, and TiO₂ compacted powders with polysiloxane as a bonding phase and carbon as a template at 600 °C in air. The porosity could be controlled between 66% and 74% by adjusting the amounts of polysiloxane and the carbon template. The lowest thermal conductivity (0.059 W/(m·K) at 74% porosity) obtained in this study is an order of magnitude lower than those (0.2–1.3 W/(m·K)) of porous monolithic SiC, SiO₂, Al₂O₃, and TiO₂ ceramics at an equivalent porosity. The typical specific compressive strength value of the porous SSAT ceramics at 74% porosity was 3.2 MPa cm³/g.     

Borage Oil Enhances Lamellar Body Content and Alters Fatty Acid Composition of Epidermal Ceramides in Essential Fatty Acid-Deficient Guinea Pigs

Borage oil [BO: 40.9% linoleic acid (LNA) and 24.0% γ-linolenic acid (GLA)] reverses disrupted epidermal lipid barrier in essential fatty acid deficiency (EFAD). We determined the effects of BO on lamellar body (LB) content and LNA and GLA incorporation into epidermal ceramide 1 (CER1) and epidermal ceramide 2 (CER2), major barrier lipids. EFAD was induced in guinea pigs by a diet of 6% hydrogenated coconut oil (HCO) for 10 weeks (group HCO) or 8 weeks followed by 6% BO for 2 weeks (group HCO + BO). LB content and LNA and GLA incorporation into CER1 were higher in group HCO + BO than in group HCO. Small but significant levels of LNA, GLA, and their C20-metabolized fatty acids [dihomo-γ-linolenic acid (DGLA) and arachidonic acid (ARA)] were incorporated into CER2, where ARA was detected at a level lower than LNA, but DGLA incorporation exceeded that for GLA in group HCO + BO. Dietary BO enhanced LB content and differential incorporation of GLA into CER1 and DGLA into CER2.     

A Comprehensive Review of Genetically Engineered Mouse Models for Prader-Willi Syndrome Research

Prader-Willi syndrome (PWS) is a neurogenetic multifactorial disorder caused by the deletion or inactivation of paternally imprinted genes on human chromosome 15q11-q13. The affected homologous locus is on mouse chromosome 7C. The positional conservation and organization of genes including the imprinting pattern between mice and men implies similar physiological functions of this locus. Therefore, considerable efforts to recreate the pathogenesis of PWS have been accomplished in mouse models. We provide a summary of different mouse models that were generated for the analysis of PWS and discuss their impact on our current understanding of corresponding genes, their putative functions and the pathogenesis of PWS. Murine models of PWS unveiled the contribution of each affected gene to this multi-facetted disease, and also enabled the establishment of the minimal critical genomic region (PWScr) responsible for core symptoms, highlighting the importance of non-protein coding genes in the PWS locus. Although the underlying disease-causing mechanisms of PWS remain widely unresolved and existing mouse models do not fully capture the entire spectrum of the human PWS disorder, continuous improvements of genetically engineered mouse models have proven to be very powerful and valuable tools in PWS research.     

Validation of avenanthramide and other phenolic compounds in oats and sprouted oats and their antimicrobial properties against Escherichia coli O157:H7

Food Science and Biotechnology - Oat contains a variety of phenolic compounds, including avenanthramides, which are found only in oats. This study was conducted to establish the quantitative...     

The Effect of Interface Cracks on the Electrical Performance of Solar Cells

Among a variety of solar cell types, thin-film solar cells have been rigorously investigated as cost-effective and efficient solar cells. In many cases, flexible solar cells are also fabricated as thin films and undergo frequent stress due to the rolling and bending modes of applications. These frequent motions result in crack initiation and propagation (including delamination) in the thin-film solar cells, which cause degradation in efficiency. Reliability evaluation of solar cells is essential for developing a new type of solar cell. In this paper, we investigated the effect of layer delamination and grain boundary crack on 3D thin-film solar cells. We used finite element method simulation for modeling of both electrical performance and cracked structure of 3D solar cells. Through simulations, we quantitatively calculated the effect of delamination length on 3D copper indium gallium diselenide (CIGS) solar cell performance. Moreover, it was confirmed that the grain boundary of CIGS could improve the solar cell performance and that grain boundary cracks could decrease cell performance by altering the open circuit voltage. In this paper, the investigated material is a CIGS solar cell, but our method can be applied to general polycrystalline solar cells.     

Antioxidant and antimicrobial activities of fresh garlic and aged garlic by-products extracted with different solvents

Food Science and Biotechnology - This study aims to investigate antioxidative and antibacterial properties of fresh garlic (non-aged, NG) and aged garlic (AG) by-products extracted with distilled...     

Toxoplasma gondii GRA9 Regulates the Activation of NLRP3 Inflammasome to Exert Anti-Septic Effects in Mice

Dense granule proteins (GRAs) are essential components in Toxoplasma gondii, which are suggested to be promising serodiagnostic markers in toxoplasmosis. In this study, we investigated the function of GRA9 in host response and the associated regulatory mechanism, which were unknown. We found that GRA9 interacts with NLR family pyrin domain containing 3 (NLRP3) involved in inflammation by forming the NLRP3 inflammasome. The C-terminal of GRA9 (GRA9C) is essential for GRA9–NLRP3 interaction by disrupting the NLRP3 inflammasome through blocking the binding of apoptotic speck-containing (ASC)-NLRP3. Notably, Q200 of GRA9C is essential for the interaction of NLRP3 and blocking the conjugation of ASC. Recombinant GRA9C (rGRA9C) showed an anti-inflammatory effect and the elimination of bacteria by converting M1 to M2 macrophages. In vivo, rGRA9C increased the anti-inflammatory and bactericidal effects and subsequent anti-septic activity in CLP- and E. coli- or P. aeruginosa-induced sepsis model mice by increasing M2 polarization. Taken together, our findings defined a role of T. gondii GRA9 associated with NLRP3 in host macrophages, suggesting its potential as a new candidate therapeutic agent for sepsis.     

Early-warning performance monitoring system (EPMS) using the business information of a project

An early-warning performance monitoring system (EPMS) is proposed to objectively measure and monitor the performance of a project for early detection of inherent poor performance problems. The EPMS is built based on project progress data and consists of a database of business information, an optimized theoretical model used as a performance measurement baseline, and an index for monitoring and forecasting the performance. By monitoring the performance through an application of the EPMS to the Korean construction project, the quarterly variation of index was found to differ by project type. These results could explain the environmental changes in the project execution. Therefore, the EPMS is expected to be an alternative for objective performance monitoring and forecasting while applying the existing methods is difficult because of the limited available data on performance indicators. The development procedures may also be useful to researchers interested in approaches to quantitatively analyze trends in various industries.